lost loads of channels

Hi Everyone,
Since last week, I have lost loads of channel on my *view1 in TW area. I have done a factory reset & full rescan with no Joy?

Is anyone else having this issue?

Thanks
SD

Most people on Telewest have had problems recently.
Did you do a rescan from a direct feed.No splitter
Have you turned the Emu ON
If so Try Menu-Installation-Manual Scan-Down Frequency 000000-
Network Scan Enable (change with R/L arrows on remote)
Wait a moment press OK

jonpc wrote:Most people on Telewest have had problems recently.
Did you do a rescan from a direct feed.No splitter
Have you turned the Emu ON
If so Try Menu-Installation-Manual Scan-Down Frequency 000000-
Network Scan Enable (change with R/L arrows on remote)
Wait a moment press OK

Hi
I have done all this apart from the last network scan bit... Will give it a try and see how it goes

Thanks
SD

hallejuah

[quote="JonB12"] hallejuah[/qu

Can you state what you did it as may help others.

Well Done

hey, i thought the codes have changed as i lost loads of channels but i realised that i had to do what you lot did. i really don't understand, can anyone explain more clearly as i have no idea what you're talikng about.

thanks alot

Doing a re-scance by going into the following via remote

1.) Menu
2.) Installation
3.) Changing the network to your desired area
4.) Do full network scan
5.) Automatic
6.) Press Scan

hey, thanks for the advice but the channels are still not working. Is there any other way that i could get them to work? I've also tried scanning from a 'direct feed' but i don't understand what that is. Can any please explain?

JonB12 wrote:hey, thanks for the advice but the channels are still not working. Is there any other way that i could get them to work? I've also tried scanning from a 'direct feed' but i don't understand what that is. Can any please explain?

Please read the second post in this topic all you need is there.

thanks but where do you go to scan from a direct feed (no splitter)?